Newtek TriCaster Advanced Edition User Guide Uživatelský manuál Strana 296

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 342
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 295
Page | 284
FIGURE 328
This virtual multi-monitor effect depends on a single clip (played from a DDR) which is itself a montage
composed of a number of different looping video clips composited into a single frame (e.g., Figure 329).
FIGURE 329
FIGURE 330
Hint: A template clip (Figure 330) is supplied in the Clips>NewTek folder (as are several looping sample clips). You
can use the template as a guide to prepare similar clips with content positioned correctly for use with the Nightly
Show set, using in the software of your choice.
To configure the effect:
1. Assign your talent shot to Input A in the M/E tab
2. Put the looping montage clip you prepared in a DDR, and select that DDR as Input B.
This particular set was designed to work with all TCXD model TriCasters, including those supporting just two
primary sources. For TriCaster 8000 (only), which adds C and D inputs in M/E panels, the set has been
updated as follows to provide more ability:
Input C targets the ‘virtual ticker’. Knowing this, you might for example use Input C’s positioner to
compose a LiveText feed (from a Network input) to correspond to the lower right quadrant of the
template clip (as seen in Figure 330 above). This would then be mapped to the ticker, allowing you
to update the virtual ticker remotely.
Input D is mapped to the virtual ‘control room monitor displays’. Position another source to conform
to any of the numbered input areas of the template clip to replace the corresponding ‘screen ‘in the
virtual control room. This allows you, for example, to send live video switched in another M/E to one
of these monitors.
Zobrazit stránku 295
1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 341 342

Komentáře k této Příručce

Žádné komentáře